🔌 DROK AC Voltage Current Monitor: 80-260V 100A LCD Display for Power, Energy, and More! Review

This meter works exactly as it was designed for its purpose. I use it to determine the power of devices used with an inverter. In the picture it is outside of its black box with no load connected and shows 120VAC - 0.05A or 50mA - 0.5W. I have tested this meter from 16W to 750W and it is very accurate. Guess why it reads no load? Think before you answer. Remember that regardless of whether the device is on or off, there is still a wire going through the CT that has potential, which is 120 VAC…

Not sure how the image would appear online as it kept putting it on the page no matter what I tried. I needed a way to control power to both phases of a 50 amp switch in our RV because I have had a lot of problems with bad camping power supplies because bad switches usually corrode where half of the dual 50 amp circuit breaker is found Bad and many other conditions are usually the result of poor maintenance facilities. I made the block shown to show both phases, A at the top and B at the…

I bought this meter to check the current draw of various devices I plan to use in my trailer. I installed it in some sort of plastic switch box I found at a hardware store. I didn't want to use a large double box and found them for less than $2 including trim. I was hoping to mount it in the rosette but it wasn't big enough so I cut out the side of the box with a rotary cutter in a Dremel tool and it made for a pretty neat installation. I bought a cheap extension cord (14 gauge) to run out of…