🔥 Dynatek 2000i Ignition System: Enhanced Efficiency for Single Plug Single Fire Applications - Coil D2KI-5P Review

definitely a good device while it's amazing. I've only been in my S&S for a few weeks. so time will tell. I'm a little nervous because the heat in the nose cone affects the electronics. He was at my door in 4 days.

I'm a certified technician everything works as it should and a beginner with the right tools can install it following the instructions. In my opinion, Dynatech makes the best parts that best withstand the Phoenix and Vegas heat of summer riding.

I had a Hi-4 faucet on my bike and it crashed. I've read a lot of bad things online about this system. My friend told me about Dnatek and my bike is running better than ever

Good deal works well. came quickly I can't be wrong If your bike cuts off from you, then starts again after a few minutes, runs fine, or spat and fails, you need a new ignition. When it goes out again, I'll take it out of the nose cone and put it under the seat. But the Dinatek will go.

The product was easy to install. The instructions are well written and clear. After the initial setup, the bike started right away. I noticed an easier no-recoil launch, which was the reason for the installation. My first ride showed quicker throttle response and shifting the rev limiter at 6000 rpm is a hit! Anyway, so far this is a great addition to my already great 1998 EVO Low Rider! Ernie from New York

Great product. Real Bolt. Better start, cleaner ride, more power and better mileage. It takes 1 to 2 hours to install, which takes one time. Instructions and diagrams are simple, clear and concise. Eliminates the ignition block under the seat. I had a problem in that my steering wheel (run/kill) switch although it worked fine on OE had to be replaced in order for the new unit to work, although tested for continuity this was the weak one Element. It's a good idea to verify your information…