Header banner
Revain logoHome Page
πŸ”₯ dywishkey pointed tip narra leather burnisher slicker tool drill sets-1/8 inch shank for dremel rotary tools (2pcs): efficient leatherworking accessories logo

πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories Review

5

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.6
πŸ‘ž Leathercraft, 🧢 Crafting

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories
img 2 attached to πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories
img 3 attached to πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories
img 4 attached to πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories

Description of πŸ”₯ DYWISHKEY Pointed Tip Narra Leather Burnisher Slicker Tool Drill Sets-1/8 Inch Shank for Dremel Rotary Tools (2Pcs): Efficient Leatherworking Accessories

√ Material: Ebony. √ Use: Perfect for Dremel rotary tool, drill press, hand drill, lathe, or any other motorized tool. √ Simply wet the edge of the Leather and then add either saddle soap or glycerin for a fine burnished edge. √ Design: Its outstanding pointed tip will allow you to effectively finish tight corners, small holes, slots, belt loops, and difficult to reach edges. √ Can polished leather skin side to side several widths for different thickness polished leather; This burnisher is ideal for finishing holsters, knife sheaths, saddles, etc.

Reviews

Global ratings 5
  • 5
    0
  • 4
    2
  • 3
    1
  • 2
    0
  • 1
    2

Type of review

Revainrating 3 out of 5

He half does what he says.

Skinny Tool works great! I can run it at any speed my rotary tool can handle and it works fine. The wide instrument is so unbalanced that it shakes at the lowest settings (1000 rpm) and my instrument sounds like it's falling apart. I give 3 stars because the flimsy tool works well.

Pros
  • Leatherworking Accessory
Cons
  • Can't remember

Revainrating 4 out of 5

Really well made ebony burnishers

Really well made ebony burnishers but the shanks are slightly smaller (0.11 inch) than 1/8 inch as described. I couldn't tighten them in my 1/8" collet. I had to stretch the smaller collet to hold the polishers. If you're using a drill press with a Jacob chuck, you'll have no problem.

Pros
  • Manufacturing
Cons
  • Questionable older purchase

Revainrating 1 out of 5

Flex immediately! Not a good product, Amazon should get rid of them!

About 5 minutes after opening the box, my husband put one on his Dremel tool. As soon as he switched it on, he immediately leaned forward. When he thought she wasn't wearing right or something bad, he put on another one and she immediately bent over and then flew away spinning like a top on the ground! What a rip off!

Pros
  • Arts, Crafts & Sewing
Cons
  • boring packaging

Revainrating 4 out of 5

Don't waste your money

Junk! don't waste money. When I received them I was nervous, put the big one in my dremel at the lowest speed was a bad balance. I played around with this and did better when I increased the speed fast enough to get the job done, the shaft was bent, UNUSER!

Pros
  • √ Design: Its protruding pointed tip allows you to work efficiently through tight corners, small holes, slots, belt loops and hard-to-reach edges
Cons
  • Cord is shorter than other pickaxes

Revainrating 1 out of 5

Really nicely made ebony polishers

Really nicely made ebony burnishers, but the shanks are slightly smaller (0.11") than 1/8" as described. I couldn't tighten them in my 1/8" collet. I had to stretch the smaller collet to hold the polishers. If you're using a drill press with a Jacob chuck, you'll have no problem.

Pros
  • √ Can polish leather from side to side, multiple widths for different thickness polished leather; This burnisher is perfect for finishing holsters, knife sheaths, saddles, etc.
Cons
  • Out of fashion