ECOGARD XC35834C Premium Cabin Air Filter with Activated Carbon for Mercedes-Benz Sprinter 2500 DIESEL (2010-2020) and Sprinter 3500 DIESEL (2010-2020) - Optimized for Superior Performance in Car Air Filtration Review

This just fits in my 2016 Mercedes Benz Sprinter 3500 engine bay. It appears to be 1 inch shorter in height. But putting it that way, it was reasonably acceptable until my next replacement. Then I will measure again. Anyway, with this filter I expected it to get tighter or tighter. from all sides.

Decent quality filter. Unfortunately, like most parts I'm trying to save money on my Mercedes Sprinter, it doesn't fit. It's about 3/8 inch short. So short that the tabs holding the filter in place fail to do their job. I would like a cheaper alternative to the OEM Mercedes but am not sure if there is one.

Attached to the original MB cabin filter that I changed, the dimensions are the same. The only problem is that it's flimsy and lame when installed. This causes the top clamps to fail, leaving a large gap for unfiltered air to enter. The original filter is very stiff, especially around the filter frame. The phrase "you get what you paid for” applies here. I wouldn't buy this again. 2012 MB Sprinter.

This product was two or three times better than the factory original but here's the thing, it's about a half inch or a quarter inch shorter than the top below, so I had to disassemble the old factory air filter by removing the plastic housing and adding it to this somewhat small but exceptionally good filter, good thing I didn't throw away the old one right away it wasn't that hard to change so what am I complaining about

does not fit so what do you like about it? All dimensions are slightly smaller than the OEM filter. I tried installing an Ecogard filter and it had gaps all over it. I did this by cutting strips of cardboard and inserting them between the filter and the sides of the filter holder. If it works I will continue to use the filter until it gets dirty but I will not buy it again. I guess it's fair to say you get what you pay for. They were around $20 and dealer OEM filters were $40. An Ecogard filter

The product was the same size as the factory filter but did not have the plastic top and bottom (see my picture) as shown on the Revain website (see their pictures). The airflow arrow seems to be upside down from the factory MB filter (see my picture) if you pay attention to the orientation of the side flaps. Installing in line with the flow arrow on the replacement filter will not provide a good seal. The instructions that came with it say the filter is for a 07-08 Dodge Sprinter, while the…