Edelbrock 8008 THROTTLE LINKAGE Review

These carburetor studs were fitted to a new aluminum intake manifold. Perfect length and well finished with clean treads. Don't invent modified bolts or look for comparable studs. Arrived on time, complete with sprockets and nuts.

The stud kit was just what I needed. Carburetor tuning requires patience to remove and installation can damage the threads on the intake manifold. This kit fixes this problem and also makes it easier to align the seal.

The kit provided the pitch and thread length I needed. Always check the length needed for the installation and add the length needed to the total length. Consider placing spacers, clips, etc. on the stud or studs to measure the overall length. Be sure to leave enough space for the nut and washer.

This rivet set is great. It worked great on my Edelbrock dual tier air intake to accommodate a 600cc Edelbrock carburetor. feet per minute. And please do not check the carburetor installation before installing the bolt kit so you know where the bolts are on the back of the carburetor. I had to put the bolts closer together inside. so that the screws do not hit the carburetor. and be safe and always use anesthetics on the threads. Because when the engine is warm, the studs close so tightly that…