Effortlessly Loosen Stuck Fasteners With KAIFNT K504 Heavy Duty Impact Driver Set - 24 Pieces Review

Sometimes I end up with a screw or bolt that just doesn't want to come loose and I know if I keep trying with my power driver, I am just going to end up damaging the head to the point where the bit won't bite.In those cases, this tool is just what I need to apply a little persuasion. The impact of the hammer drives the bit into the head at the same time that the rotational torque is applied, helping to keep the bit firmly seated.For those times where that doesn't work, or more likely, where I…

This is great for getting into tight places where you can't get an impact driver or long socket wrench handle! It easily breaks screws loose and then can be used as a screwdriver to remove them, or you can use the 1/4" or 3/8" socket adapter to break loose and remove bolts with your impact sockets.The case is decent but uses a living hinge that will have to be replaced with duct tape eventually. It does latch tightly and keeps the parts of the kit from moving around while you carry it.The kit…

Affordable manual impact extractor kit. What that means is you whack the end with a hammer to get the "impact effect" force which is usually what you need for stubborn fasteners.Some of the bits are not impact rated (the 1/4 hex phillips etc.) brittle they break. hence I dinged it a bit. overall its handy to have around and the few fasteners I have had to use it on it worked well to remove them.

I use this tool to take off rotor retaining screws, it's a very useful tool with all the sizes you will need, can withstand hammering down and getting off rusty stuck screws as opposed to drilling them out or grinding them, since I used it I was able to save the screws for reuse! And save my energy and time!It's easy to use, just grip it and turn your hand to the direction you need the force to go (counterclockwise/clockwise, to remove/install), and it will switch to that direction and then…

Feels solid but is still far more compact than my old impact driver. So I assume this one isn’t as heavy duty as the 2.25” diameter version but it does still feel really solid. I have a plan for this one to get a set screw in a coupler that my bulkier one can’t get near. I haven’t used it yet but when I get to it in the next week or so I will update my review

Does exactly what you’d expect, frees very tight machine screws. Used to remove the strikers on my ‘66 Mustang and this tool paired with a 3 pound brass sledge freed the screws with two strikes. Would recommend.

I use this one as a technician almost every day. Works like it should, would buy again! Very complex set of bits, and the quality is the best(heavy duty )