🌡️ High Accuracy Electronic Thermostat Controller - DROK DC 6-30V 24V Digital Temperature Control Board: -50 to +110 Degree Celsius, LCD Digital Micro Temp Control Switch Module with Waterproof Sensor Probe Review

This device has only been in use for 2 weeks but so far it works exactly as I had hoped. In the winter I have to blow out 2 basement windows a bit when the vinyl frame hits the dew point or else condensation will form on these windows and freeze causing a mess. These windows were installed in the outermost part of the poured concrete wall, which was a mistake, but it's easier to blow air in than to get it to the inside of the wall. On this unit, I set the turn on temperature a few degrees above

It needs a simpler language to describe the connection lover and describe the main functions. This is a relay switch: Heat - Normally Closed Cool - Normally Open During the cooling cycle the temperature rises to the set level required to turn on. Example - if C34 is set, up to what temperature should it be cooled? If 35 degrees Celsius is desired, set the range (top of screen) to 1.0. The device turns on at 35 and then turns off when it cools down to 34. Also, if you're using a low voltage…

I'm having trouble programming, I need help or more detailed instructions. If I set the temperature to 30 degrees and the second to 28 degrees, it doesn't work. Only when I set 30nc and the next one is 9c does it turn on. It used to work, now all 4 boards do. I made a mistake, could you please explain the shortcut in the menu what it is or email me to better understand the programming. I quickly press Set, then select c, then 30°C, and then the next setting 28°C. Now it works. The second must…

I can't find a price for the functionality of this controller, but I'm again stuck without a working system, having just received my replacement order. I haven't even shipped the first controller which broke within two weeks and the new one stopped working due to repeated sensor failure. I only use the controller to turn the fans on and off above the aquarium. I conclude that the probes are not waterproof. I've done my best to secure a controller that at least works as advertised, but the…

The only complaint I have about it so far is the complete lack of any documentation on how to use it. Plus, it worked great for the 45 minutes I spent with it. However, after playing with it for a few minutes, I figured out how to use it. Here's the scoop if it helps anyone: 1. Apply power to the +V/-V pins on the terminal block. I used a 12v power supply and everything worked.2. Connect the thermocouple sensor. Mine has hooked up so you may not have to.3. Connect the object you want to control