🔌 Round Style RDBS 12V LED Electronic Turn Signal Flasher Relay - 2 Prong - 2 Pin Flasher Relay Review

I bought it because I installed new LED bulbs. 7/4/19 It's a bit bigger than my old Tridon but I don't have a fuse box cover in my s10 so the gap wasn't a problem. It makes a clicking or ticking noise when blinking, which my other one didn't, but that doesn't bother me. Good buy, I will change this rating in the future if something happens.

ON THE GOLF CARD FOR LED SIGNALS. I RUN IT FROM THE BATTERY TO THE SWITCH; N/G, I RUN THIS FROM THE BATTERY AFTER THE SWITCH BEFORE THE LED; N/GI WAS TOLD BECAUSE I USE LED LIGHTS I NEED "ELECTRONIC MAGNETIC FLASHER CONTROLLER" AFTER THIS DID NOT WORK, HAVE I BUYED A SECOND MAGNET THAT ALSO HAS A SEPARATE CABLE? (FROM THE SAME COMPANY)

Replaced all the bulbs on my 96 F350 with LEDs. Bought to replace the original mechanical flasher relay. Works as intended, direct plug replacement for fuse box. My only issue is that it's twice the height of the original module, so the fuse box cover doesn't fit properly. I had to make some jumpers so I could put this module aside to close the fuse box.

I installed this on a 1980 Kawasaki KZ1000 motorcycle. All headlights (headlights, turn signals and brake lights) are converted to LEDs. None of the turn signals flashed prior to installation. After installation, the turn signals will flash at a frequency of about 1 second. Seems to be working very well so far. The turn signal is audible so it can be heard when the bike is not running. Otherwise no problem. No ratings on durability as it was just installed (12/14/20).

I installed this turn signal when I was converting the turn signals from incandescent to LED on an old car. This device is specifically stated to work with LED bulbs, incandescent bulbs or any combination thereof. It is not. As other reviewers have pointed out, it will not blink unless there is at least one bulb in the circuit. Even then, it blinks a bit on the slow side. After replacing the flash driver with a completely electronic one (https://www.amazon.com/gp/product/B08LQGDM9Z/ref=ppx_yo_dt…

I got LED turn signals for my 1995 Bronco and instead of putting in those stupid resistors I went with electronic turn signals. I bought all of these things from a well-known online store that specializes in these things and I didn't realize that my Bronco required two separate turn signals - turn signals and a 4-way turn signal - so they sent me the wrong turn signal . Then I looked here at AMZ and got this one. It works GREAT. Landing problem because the indicator is too high instead of the…