💨 High Pressure Hand Pump with 3 Stages for Charging Gas Filter Gauge Valve Hose - Up to 4500 psi (Silicone Oil NOT Included) Review

After 30 years of shooting spring piston airguns I decided to try the PCP side. I've been using this pump for a few weeks now. I've filled my Hatsan Flashpup 12 or 15 times and the pump has never let me down. I didn't have instructions but assembly was easy and there are many youtube videos to help you understand how it works. The only issue I had was that the plug that came with it (to check for pressure leaks) didn't fit the outlet. Make sure you have some silicone oil with you, although mine

Absolutely first class fit and finish of the PCP pump. Constructed from stainless steel and machined brass. Works perfectly. Instructions are ready to use in photos. Some basic knowledge of PCP pumps is required for assembly. filled my bar m lightly, used silicon tape with compressed air threads on the gauge and hose and even on the crank pins. Just in case. It also guarantees hassle-free assembly. The bleed screw was a bit tight at first. The included end fits directly into the standard silver

This pump is very well made, the quality is amazing in my opinion. I contacted the seller and got a reply the next morning. This water-cooled pump comes with spare parts and stainless steel filters! This is an easy to pump, easy to use pump. I have recommended this pump to other Airgun Nation members. That's how I liked it. Excellent price. Buy it! This is an update. My new pump had a leak at the suction port, I replaced the seals and it's still leaking. I contacted Ochun via email and they…

I bought it as the first pump for my first PCP. I now have two PCPs and have been using the pump for 5-6 months and it works great. I have a Hatsan AT44 and a Flashpup in .25, both firing about 40 shots before reaching 100 bar where I reload. Usually when shooting a friend who has an AT44 I use the pump to reload both guns at least 3 times each before we stop firing. I lubricated the pump when I got it, it has no heat problems, after about 70 continuous pumps and a break, both inside and…

Great pump. Works great with the vent on my .25 caliber Airforce Escape. A great alternative to pumps from other brands. This one costs $100 less! The problem I've had so far is the o-ring where the bushing screws onto the hose. It blew constantly, causing it to leak. It was too thick and when you tightened it pushed out instead of sitting in the thread groove and as you increased the pressure it dislodged the o-ring from its place. But my cousin had a set of o-rings on hand and I replaced them

New to the world of PCP airguns. I just bought a basic BPWF17 .177 sluggun and had to buy a PCP pump to load it. This hand pump was cheaper than many others, but according to the specification it was made out of the same material as expensive models. After it arrived I tried to read the instructions but it was impossible. The device is obviously overseas made and the broken English instructions would be disappointing if they weren't so ridiculously funny. Found some Chinese instructions on…