🔴 ESUPPORT Universal 12mm Mini Red Cone Cold Air Intake Filter for Turbo Ventilation & Car Breather Review

I have one on the end of the rear axle breather hose on my truck and another on the air inlet of my air compressor. Change every few years.

Purchased to fit the valve cover on my 212 Predator engine which I have retrofitted to a mini bike. The product fits perfectly as it is made of high quality materials. I will buy again

Perfect size for my PCV valve. Since I removed the airbox and put in a different filter, I needed something for the PCV. And this filter works amazingly well and fits the bike better.

Imported imitation of a useful item for large turbocharged engines. But it works. The hoses are very flimsy, so take the fuel line and cut it to connect to the valve covers and you're good to go.

IF YOU HAVE DYNA HARLEY. DEBIALS SIMPLY USE AN OPEN HOSE ON THE TRANSMISSION. Common sense tells you this is a recipe for disaster. I TURNED THIS LITTLE FILTER ON AND "PROBLEM SOLVED". NOT RISK WITHOUT A FILTER.

I used it to install just above the rocker cover vent that goes back into the carburetor on a 212cc Harbor Freight Predator engine. The short rubber hose and clamp were long enough and just the right size to provide a secure fit. Looks very nice with blue. and there it just catches and blows oil.

Got rid of that old clunky air box on my 1980 CB900C. These (two of them) were the perfect solution to replacing the engine and cross cover vents under the carburetors. They also matched the cone openings I attached to carbs. The whole setup looks great. They fit exactly on the ventilation slots (12mm). The only downside might be that the clamps are cheap and probably not stainless steel, but that's no big deal.