🏍️ Evomosa Universal Motorcycle Taillight Brake Stop Light - Ideal for ATVs Review

Works as described. Only via the running and braking function. Seems sufficient and works well with a slider to control blink rate. I made a bracket and replaced the standard screws with something shorter. Happy with the purchase

Fits as a replacement for the Baja Designs taillight on my XR650r. Not sure about durability, I'm concerned that the wires going into the case will be exposed and could be broken by wheel debris. I reinforced them with heat shrink but it would be better if they were in a more durable coating. Good price.

Super bright LED brake light and license plate light. Much brighter than the bulb I replaced. The quality is ok, it's just plastic so that's to be expected. My only gripe is that I wish the license plate light wasn't at the very end of the housing as when pressed against a flat surface it cuts off the light a bit. However, this is not a big problem.

I installed this on my ATV because I need something, but I wouldn't recommend using it on a motorcycle. This light is not very bright and not noticeable so I would be scared if it was the only thing people saw to avoid meeting me on a motorbike. For the price it's good for other things like an ATV which is what I've used it for.

Overall a good little light for $10 or less. Bought for my ltz400 '03. Has not been ridden since installation so durability has yet to be determined. It's small, not sure I'd use it on a road bike, but it's bright enough and big enough for an ATV. (NO DOT MARK) The wire colors were different than the picture but it was clear. Works as clearance and brake light.

I installed this light and it didn't work at all. I've installed car stereos before, so I'm not new to wiring. It's as simple as it gets: 3 wires: black to black, yellow to yellow, and red (my bike) to blue (light). The light didn't work. I wasted my time modifying my plate mount to work with the light and took everything apart. Luckily I left enough wires to turn my old light back on. Disappointing. Honda CBR600RR 2012

I bought this because I needed a license plate light for the back of my UTV. I thought this would also add a third brake/tail light to my car. The first headlight I received was defective and the tail/brake light was not working properly. I contacted the seller and he sent me a replacement within 2 days. I have driven my car hundreds of miles since installing this light and it still works. Some of the trails were pretty rough including a double black diamond trail on the Paiute trail. A word of

This is a kind of cool light that can be added. I've wanted a good LED kit for my motorcycle for a long time. One problem I have is that it says it's a straight bolt, so I figured that means the bolts matched the license plate bolts. He's too small for that. The bolt spacing is about 4 inches and the holes in the motorcycle plate are about 5 3/4 inches apart. I probably should have checked the measurements before I ordered it. I'm going to drill holes in the board and lay it on the floor…