Header banner
Revain logoHome Page
extractor replacement activated absorber xytronic logo

Extractor Replacement Activated Absorber Xytronic Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🔧 Industrial Power Tools, 🛠️ Industrial Power & Hand Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to Extractor Replacement Activated Absorber Xytronic
img 2 attached to Extractor Replacement Activated Absorber Xytronic
img 3 attached to Extractor Replacement Activated Absorber Xytronic
img 4 attached to Extractor Replacement Activated Absorber Xytronic

Description of Extractor Replacement Activated Absorber Xytronic

Kulannder extractor filter replacement activated fits for Hakko Corporation 493 and FA-400, Xytronic 426DLX and 456DLX and Aoyue 486. How often should replace your carbon filter? Normally activated charcoal filters should last 4-5 months should replace a new filter. This smoke fume absorber filter can take the smoke away very well, thick well made filter, works well for your fume extractor, homemade DIY fan.etc. Enough quantity and size: totally 6pcs carbon extractor filter, each carbon filter dimensions are 130mm*130mm*10mm(5 1/8” * 5 1/8” * 3/8”). Extractor filter only, not include smoke absorber! Guarantee and Warranty: any quality issues, just contact us for refund or replacement.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

I think the filter works.

Custom exhaust system with a 120mm fan, 3D printed air duct and these filters. Seems to be working fine. My workshop smells significantly less of rosin after soldering.

Pros
  • Welding and soldering
Cons
  • The cable is shorter than other picks

Revainrating 5 out of 5

Ideal for multiple uses!

I originally purchased this filter to install in a 3D printed solder fume extractor. It works great for this since that is its main purpose. But I also installed it on the exhaust hood of my 3D print case to clean the air when I print with smoke-generating plastic. It works great for that too. This is a good solid carbon filter that can be used for many filtration tasks.

Pros
  • Soldering and Soldering Equipment
Cons
  • Discontinued

Revainrating 3 out of 5

Kind of works for soldering fumes.

Call anyone hoping to only use 1 of 6 Solder Fume Extraction. It doesn't work with just one. The smoke was reduced by about half. So two can work. However, if you want to be sure the smoke doesn't get through, hold it up to a light. With the way I see the light (simply by pointing it at the ceiling light from the floor). 1, you can see the light through it. .2, the light is worse to see 3, almost correct 4, almost no light to see 5, I can no longer see the ceiling fan light You can add a 6 to…

Pros
  • Fume Extraction and Fume Extraction
Cons
  • Small Parts