🚦 High-Mount Stop Light with Seal Gasket - LED 3rd Brake Light for F150 (2004-2008) Tail Cargo Lights Review

Nothing wrong with the product or the company - just wasn’t right for my truck. Wasn’t as bright as I had hoped and it sat too ‘proud’ for my preference.

I had to shave down some of the plastic with a Dremel cut-off wheel for it to fit flush in the opening on the back of the truck cab. Shaving this plastic did not alter the integrity of the housing. Now it fits tight like the OEM it replaced. The LEDs look great. The brake lights and cargo lights seem brighter than the OEMs.

I have a 2016 Silverado 1500 and this did not even come close to fitting. The bad portion of the light housing has a large rectangle that hits on the metal of the truck. I tried angling it but I don't think the holes would have lined up even if I did get it in.

Great product and plugnplay but it never turns off. It's always just barely on. No idea why, has not drained my battery. I left my truck for a week and it started right up. Installed on 2007 F150

The light fit perfectly over the old location. I was pleased with having a gasket that stayed in place while installing and sealed to the truck. There are even small seals for the two screws that go through the light. I only wish there had been new black screws included since my others have a little rust on them. Fully recommend.

Install only took 10 minutes. Doesn't completely site flush because the foam padding is wider than it should be for 2011 ram 1500. The LEDs don't give off a lot of light. But overall, good for the price.

noi instructions provided but it was easy plug and play shows bright and works great would have given a five but no instructions.

Great looking product, clean look. Hopefully the smoked look will not show dirt like the factory clear one would around the rim (will update later on that) one thing I did not like was the screws that came with this product, I ended up using the factory screws.

I was actually installing this on a battery powered trike. LEDs dead as shown in pics. I can't return it because I had to cut the end plug off the wires to wire up to the trike. Unfortunately I didn't know the LEDS didn't work until AFTER I cut the wire.

I like the how bright it is, good quality but it didn't fit like the original the bottom part had an opening and I had to use caulk to fill it in, other than that it worked fine!

I like the way it looks as of right now no leaks Ford 2010 xlt light’s up very nice when installing remove the bulbs from the old light plug into new light where the bulbs where middle and right side it should work

These lights were easy to install on my dad’s older pickup. Very bright and easy to see from a distance; a good safety feature !

The light does not even come close to following the contour of the cab! 👎🏻It doesn’t come with new screws so you’ll have to use your old rusty ones.Wish it would have been better thought out, either mfg doesn’t care or it’s a "one size fits all” deal, maybe they sent the wrong one but it’s past the return date so it’s a wash all the way around.

It fits nicely and it lights up red when you push the big pedal in the driver's floor board plus it has a bright white light that comes on when you might need a little bit of light to see ya cargo box after dark.

After looking all over YouTube and the internet for a fix, I decided this item sadly had to be returned.1. This is unfortunately not completely "plug and play”. My 2010 F-150 FX2 has a 3rd Brake light that does illuminate (white) when I am reversing, when my doors are open, and when I turn the light on manually from the inside. I love this feature because it is incredibly useful at night, while camping, at the drive in to get set up, etc. If that means my wiring was done differently, then I’m…

I bought this because I have a leak coming from my passenger grab bar, water is getting in from somewhere. I read that replacing the gasket and/or 3rd light may fix it. The lights work as they are supposed to. However the two plastic pegs broke during install. but it screwed in snug. The gasket is thicker than the OEM version so it doesnt sit perfectly flush. Overall not bad.

It's fit good however the wiring would not connect to the existing wires wires I had to cut the wires and then spice them the center wire worked but the 2 sides for the white lights I had to splice