Upgraded Firehawk 2021 9006/HB4 LED Bulbs - 15000LM Japanese CSP, Enhanced Brightness by 🔦 400%, Improved Night Visibility by 200%, 6000K Cool White, Halogen Replacement Conversion Kit (Pack of 2) Review

Replaces the stock 9006 HB4 halogen bulbs with these Firehawk LED bulbs. Installation was very easy and took about 5 minutes. They are very bright, much brighter than halogen lamps. I've considered going with another brand that has a total light output of 20,000 lumens (10,000 each), but some users have found that they glow in oncoming traffic because those bulbs were too bright. I like 15,000 lumens. Bright enough and at the same time not too bright to disturb others. The seller gives a 2 year

I tried another brand but it wasn't brighter than my halogen bulbs so it didn't last long. These little ones shine a little, I would say at least 50% brighter if not more than my native halogens in my KIA. The only problem was that I had ordered the headlights and the fog lights at the same time and when they arrived it took me 10-15 minutes to play around with the first set only to realize they had put them in the wrong boxes. Maybe they were a return and a previous buyer changed them, I don't

Better than my expensive "Signature" LED headlights. They are designed in Japan so they look very nice and should work reasonably well and reliably. I'll edit this once I've had them for a while. They are much brighter, quieter, smaller and easier to install than 90% of the other LED lights I have installed on my cars. For me, NO BALLAST is the best! I strongly advise you to check your adapter as the one sent to me does not fit. I was fortunate that I had stocks and supplies to make my own…

I bought these 9006 LED bulbs to complement my new headlight housing on my 2006 Honda Accord Coupe EX-L V6 MT. They replaced my existing set of LED bulbs that I was using from another brand. These bulbs seem much whiter and brighter than my previous set. The light shines much farther down the road in a nice beam and the fan noise is quieter than my previous LEDs. It's nice that it's just a simple plug and play bulb that doesn't require an external ballast. I'm keeping my fingers crossed that…

This is more difficult to install than regular bulbs as the blue o-ring head moves in the picture to be compatible with multiple models. And it comes off. The black mount is only held in place by 2 tiny white O-rings on the flashlight's red body. This causes all the light to slip out right after spinning. Nothing else holds it in the up and down position when prompted to install it, nor when assembling the jig. I just hope they don't fall out as I drive down the street. Everyone. I might come…