🔩 Ford Driveshaft Yoke Bolts N800594S100: Pack of 4 M12X1.75X27.0 Bolts Review

Does what a bolt does. Can't find them at local parts stores. Come with Locktite applied. Screw in these screws, otherwise they will turn themselves out.

I needed these bolts for my Lincoln 88 driveshaft bolts and they seem to fit perfectly. I liked that the thread was already Loctite.

If you need Drive Shaft Bolts for Ford F150 3V 5.4L, here they are. It's a good idea to replace them if you've ever removed a driveshaft and it's very old. Would buy again if needed.

Took my transmission out to rebuild. It seemed like good insurance to swap out those bolts. They come with Loctite. $3.50 a piece isn't cheap, but it's a lot better than $8 a piece from other sources.

I bought a new aluminum driveshaft for my 1992 Mustang LX and it replaced the bolts holding it in the back perfectly. By the way, if you have a Fox-bodied Mustang, replace the steel driveshaft with an aluminum one. you will thank me They cost less than 3 bills and are one of the best things I've done to the car.

These are good quality bolts. Note that some flanges have four holes for these OEM metric bolts, while the others may have four threads for 7/16" or other part sizes. tighten properly. Sometimes the right part is the right part!

The perfect OEM replacement for the driveshaft flange bolts on your Ford when you think the old ones may be damaged. Dimensions: thread M12x1.75, length 25 mm, outer diameter of the head flange 18 mm, 12-point head 12 mm. They come with a drop of thread lock and work very well. The best tool, if possible, is a 12-point socket such as the Sunex 212zm, although a solid 12-point open-end wrench should work as well.

Reusing the factory driveshaft bolts saves me money and gets me back on the road faster, but for $15 it's WORTH IT! It's cheap insurance to make my gimbal replacement a success! My project involves replacing my original driveshaft which was a factory OEM Ford. They lubricated the undercarriage of my 1998 Ford Crown Victoria. Although the factory Ford U-joints have not yet been completely removed, I decided to replace them as they are original and have a high mileage of 140,000. After replacing…