Header banner
Revain logoHome Page
πŸ”Œ ftcblock pro micro atmega32u4 module with 2 row pin header - ideal for arduino leonardo replacement (1pcs) logo

πŸ”Œ FTCBlock Pro Micro ATmega32U4 Module with 2 Row Pin Header - Ideal for Arduino Leonardo Replacement (1pcs) Review

3

Β·

Average

Revainrating 3.5 out of 5  
Rating 
3.3
πŸ–₯️. Single Board Computers, πŸ’» Computer Components

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”Œ FTCBlock Pro Micro ATmega32U4 Module with 2 Row Pin Header - Ideal for Arduino Leonardo Replacement (1pcs)

Description of πŸ”Œ FTCBlock Pro Micro ATmega32U4 Module with 2 Row Pin Header - Ideal for Arduino Leonardo Replacement (1pcs)

ATMega 32U4 running at 5V/16MHz;Supported under Arduino IDE v1.0.1. On-Board micro-USB connector for programming. 4 x 10-bit ADC pins;12 x Digital I/Os. The acceptable voltage range is 6 to 9 V. NOTE:Before running the procedure, pls install the Arduino IDE software. When you open the Arduino IDE software, pls go to the tool and choose the board "Arduino Leonardo"

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Disappointing Single Board Computer Experience

Through trial and error, I found that this board was unreliable and difficult to program. While it did have a lower price point compared to other SBCs, the frustration it caused made it not worth the savings. The one positive was that it did work with various software programs. However, this was overshadowed by the constant troubleshooting and lack of consistent results. If you're looking for a dependable SBC, look elsewhere.

Pros
  • Works with various software programs
Cons
  • Unreliable and difficult to program

Revainrating 4 out of 5

I wish they were a little cheaper but they worked fine.

Used for mechanical keyboards. All 3 worked fine. I reinforced the ports but they didn't seem to be weakened or anything. I think the colors of the LEDs are different than the "real" Pro Micros, but that was normal. The edges are a bit sharp, be careful. Would buy again.

Pros
  • Availability
Cons
  • Cleanliness

Revainrating 5 out of 5

J1 is factory soldered. Don't use the RAW pin!

2 stars removed because J1 is factory soldered around the regulator. The board and OLED screen were killed by trying to put 7V on the RAW pin. I installed a board from another seller that has J1 unsoldered and it works fine.

Pros
  • Solid finish
Cons
  • Some bugs