Ga Ferrules 0.71 Pin Lg: Optimal Connector Solution for Precision Wiring Review

It definitely fits well, but don't expect it to slip over loose wires. Use a twist around the end and twist very tight. Then start on one side and slowly feed the wire end in. You may lose a few threads, but it's better than no connection in the long run. Once it starts, rotate in one direction until you can't anymore, then rotate in the opposite direction and watch it slide straight ahead. .Adult Advice: Don't complain if you can't understand. To attempt. You are an adult, solve the problem…

I use Royal Excelene and/or Radaflex welded cables in my audio constructions and as soon as I received my package I have tested and verified both. Both fit exactly. You MUST start with a fresh, clean cut and install the tip immediately for it to work. The fit is very tight and it should work. Place the heat shrink tubing on the wire and the flared end of the ferrule and shrink and you are done. There's no need to crimp the connection if you don't have a tool (at least for these larger sizes)…

Ok. So, first of all, my 3-star rating is because these 1/0AWG tips need to be a little larger in diameter. Now I know that these reviews sometimes overlap with different sizes in the product line, and while I've ordered 1/0 AWG, 4 AWG, and 8 AWG, they all seem a bit too small for the wire gauge. With the 1/0 lugs in particular, I've had a very hard time connecting the lugs to the NVX 1/0 power cable I have (the NVX 1/0 dual amp kit). What I've definitely found to do the trick is to wrap…