Header banner
Revain logoHome Page
🌑️ gates premium molded coolant hose 21660 logo

🌑️ Gates Premium Molded Coolant Hose 21660 Review

6

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.7
πŸ”§ Car Belts, Hoses & Pulleys, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(1)
img 1 attached to 🌑️ Gates Premium Molded Coolant Hose 21660

Details

BrandGates
MaterialSynthetic fiber
Item Weight0.85 Pounds

Description of 🌑️ Gates Premium Molded Coolant Hose 21660

Specifically-engineered materials resist collapse under vacuum. Engineered to resist electrochemical degradation, the leading cause of hose failure. Pre-shaped to fit and to ensure perfectly sealed conditions. EPDM tube; synthetic fiber knit reinforcement; heat-, ozone- and chemical coolant-resistant EPDM cover. Meets requirements of SAE 20R4, class D2 and DIN 73411, class A (except for tolerances).

Reviews

Global ratings 6
  • 5
    2
  • 4
    0
  • 3
    4
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Works with mods

Adequate, sort of. I had to cut off one end. Not a big deal, but it doesn't fit PERFECTLY. The existing hose that I removed was a snug fit. This new one isn't. It will work.

Pros
  • Handy thing
Cons
  • Not bad, but...

Revainrating 3 out of 5

Had to for my 2005 Tundra

Hose was a little too long on both ends. I probably took the hose off 3 inches to fit it perfectly. It finally worked, but it took 10 minutes longer than it should have.

Pros
  • Confident
Cons
  • Empty

Revainrating 3 out of 5

A bit long on both sides

The upper radiator hose is about 1.5 inches on each side too long, I had to cut it with a razor blade so it's 3 stars except it's a good Toyota -Tube Tundra 4m7 is double cab 2004

Pros
  • Pretty packaging
Cons
  • I vaguely remember

Revainrating 5 out of 5

I had to crop. - Radiator

I had no problem cutting this hose to size. I also appreciate that the hose was too long and not too short. However, for some people, having to trim it to fit would be a problem.

Pros
  • Easy installation
Cons
  • I have no particular complaints about it, everything is fine

Revainrating 3 out of 5

Cut 2 inch for Toyota Tundra

Elbow to thermostat housing fits length but needs to cut approx. 2 inches from the other end going to the heatsink. Not a big deal, but it's not a direct replacement. It was on Tundra 4.7 2004. Might be perfect for other cars who knows.

Pros
  • Stylish design
Cons
  • Damaged

Revainrating 5 out of 5

Fits 2001 Sequoia upper radiator hose (probably all first generation)

The original started leaking and I bled the radiator when the water level got too low. Replaced the top and bottom branch pipes with Gates pipes (this is the top one). Flatten the original and cut off a few inches from one end with a hacksaw. Works perfectly with original clamps and does not leak

Pros
  • Solid surface
Cons
  • Compatibility