💧 Gates G27100 0606 Hydraulic Coupling: Cutting-Edge Efficiency for Smooth Performance Review

Cutting braided wire with a hacksaw was difficult. I removed about 5 inches below the sink to make sure only the solid tubing remained. The outer nut is screwed onto the outer rubber cover. The inner nipple is then screwed into the tip. It handles 3750 pounds with no problem. I'll do it again on the other end if that fails.

When the quick disconnect on my 100ft hose broke, I wanted to find a way to fix it at home. I bought two of these to replace both ends of the hose and they worked great. A vise is very helpful so you can tighten the fitting just enough. When I turned the pressure washer on to 4200psi this gel settled perfectly, not a single leak.

Easy to install with the right tools, vise, punch I recently bought a 10 year old pressure washer and the hose quick connectors were so worn they were constantly leaking. This is a smart way to add years to the life of your hose. I used a vise and punch, if you don't have them I'm sure the installation will be difficult. Be careful not to overtighten or you will break the fitting. . Also remember to put teflon tape on the threads or it will leak. Overall it worked great, but unless you're handy