TOYOTA Genuine (82219-35010) Sensor Wire: High-Quality Replacement Part for Unmatched Performance Review

I used this wiring harness to replace my old worn out connector on my fzj80. I cut off 2 sides of the connector, solder and shrink. Works like clockwork, no more check engine light.

So I have a 1990 Toyota 4Runner unless it fits mine everything else said it didn't fit my 1999 Toyota 4Runner but it does fit mine , so if your knock sensor is a square connector instead of a round connector that fits yours

If you try to relocate a 3VZE 3.0 V6 4Runner knock sensor / Code 52, this works in conjunction with the Bapmic knock sensor 89615-50010. I used a 15/32" drill bit to drill an engine lift hook on the driver's side block and attached this sensor to the hook with an M12 x 1.25 nut. Reset the ECU by disconnecting the battery, check if the check engine light is on. Your stock knock sensor deep in your engine probably isn't that bad, but this harness route is a good solution if you're not willing to…