🏎️ GlowShift Universal Black Single Gauge Metal Dashboard Pod - Perfectly Fits Any Make/Model - Easily Mounts (1) 2-1/16" (52mm) Gauge to Vehicle's Dash Review

I bent the mount to my liking as it is thin steel. The rear pivot screw allows for better adjustment. The matte black finish looks great. would buy again.

Perfect fit for my AEM air/fuel ratio sensor. The cup is deep, I would have preferred it, I just cut it to the right depth with a cutting disc. This is a fairly solid piece of NOT tin but steel of a good gauge.

I used the dashboard to install an iDash sensor on the steering column in my 2018 Duramax. It was the perfect solution to have a strong mount that can be removed without leaving a mark. I would recommend this and I will use it for future projects.

If your car looks like mine - 1970 model - it's difficult to find sensors and places to put them. It fits snugly in the top of the dashboard and mounts above the regular gauges in the car. It's easy and it works. Made from thin metal, it's pretty sleek and doesn't look tacky.

The cushion serves its purpose perfectly. Decent price for a decent deck. A bit troublesome to install. The actual mount screws into the back of the pod, and the mount screws into place from underneath where you place it. Therefore, it is almost impossible to mount the pod in a place where the back of the pod is close to anything. I made it work with a bolt and nut, not a bolt. But other than that, it's a decent pod. Durable and solid. It wobbles a bit, but that's to be expected. I would…

No instructions, assembly not easy, depending on installation location space may be needed on the back to tighten the assembly which is loose and difficult to assemble as it falls apart more often than tightened will hold. I have a lot of patience and that put him to the test. Luckily this was a temporary charge for the pod I was about to enter. Good stuff, just bad design. It's not 90 degrees like in the photo. Due to the horrible mounting method you can actually tilt it a few degrees, left to

I have an old BMW R90/6 where the previous owner installed a few additional sensors in the nacelles. One of the capsules is metal and looks as old as the bike, but it holds up well. The other is plastic and started falling apart a few years ago. I was looking for a decent metal accessory carrier to replace my broken plastic carrier that I could easily mount to my bike's front fork and searched to no avail until I came across this one here at Revain. Cheap for twice the price, I couldn't order…