🦏 Go Rhino 281731T Rear Light Plate with Textured Black Powder Coat Finish (BR20) Review

So I ordered them with abr 5.5 bumper to find out they don't work with this bumper instead of bolting on the plates that came with the bumper I cut them off. to mount and use surface mount lights but they do not work directly with the BR5.5 bumper and the Rhino does not have an option

These are tinplate to match the quality of the bumper and should have been included! Coverage is negligible, as is the bumper. It was bought for a project truck with a price in mind. I wouldn't put that combination on a $50,000 truck! They want you to lock the spare tire - attach the sensors with double sided tape and you lose the ability to lock the spare tire - stupid license plate lights (witch required) - and then pay another 220 for the lights and another $ for Linex or paint everything…

So I bought a Go Rhino bumper with light bar, winch plate and these backlit inserts to replace my fog lights from my Ram 2500. I appreciated that the panel had to be sanded on the inside to accommodate the lights I sent Go Rhino. These lanterns had slightly rounded tops and bottoms and square sides. The slab was perfectly square, so it had to be rounded off a bit. It's not hard work anyway, but you would think they would send bulbs to match the adapter they sell. There is no wiring harness, but

If you're not planning to buy a hammer drill, don't buy it. The holes don't even come close to matching the holes in the bumper. Also, they stamp the serial code right on the front of the templates (why would you do that? Obviously, they don't control the quality anyway). I accidentally ordered two sets, both sets didn't fit, so I know it's a product issue. One of my templates also had a serial number on the front. These are GoRhino branded templates, which is unfortunate as they fit as if a…

I bought these from stock and was pleased to find they were exactly as described, 'like new'. No scratches or chips anywhere. They didn't come with screws so I had to go to Low but I figured I had to go anyway because I wanted to use stainless steel fasteners. Installation was relatively easy, but there are two screws that are very difficult to access due to the bulge on the bumper. But it wasn't impossible, it just took a little longer. The couple noted that there is a part number on the…

If you want them to match your Go Rhino rear bumper and D2 Rigid Industries headlights, remember you need more than just a bumper and headlight. This is NOT plug and play. You need to buy a mounting kit from Rigid. There are instructions in the kit that recommend using plywood to mount the light behind the kit. Not good if you have a car that drives outside and gets wet. If you're like me, you bought headlights and a bumper for a car that goes off-road. Plywood is not the best option, and…