The BATTERY project was unsuccessful.
Only approximately sixty minutes of shooting time can be obtained from the brand new native battery. If the camera is not turned off completely, then the battery will continue to be used quite actively even when it is in standby mode and the screen is turned off. At the same time, a significant amount of energy is being wasted: not only does it heat up noticeably when it is set to the shooting mode, but it also gets noticeably warm even when it is turned on but does virtually nothing. It is abundantly clear that both the hardware and, more importantly, the software in question are not optimized.
What do we end up with as a consequence of this? You are only able to shoot a scene that has been pre-planned if you only have one standard battery pack. There is a possibility that there is not enough battery for all of the various kinds of searches for plans, waiting for moments, and other arts. Also, for the purpose of shooting "everything in a row," it will most certainly not be sufficient.
Then there is another issue that is connected to this one. Because Because the running time is measured in minutes rather than hours, you should always keep in mind that the battery will run out of juice soon and that you will need to replace it. And to accomplish this, let's say while free falling from a height of one kilometer above the ground, it will be somewhat challenging to say the least. Because of this, you are going to mess up the shooting.
In conclusion, in addition to the battery for the box, you will only need to purchase two to three additional batteries and a charger for them (otherwise it will take you all day to charge them one at a time). And this (let's take off-prices off-site) comes to 2 times $30 plus $65 total. Even more than a third of the cost of the camera itself, those are required for shooting in more or less comfortable conditions while out in the field during the day. And it can be charged via USB. In addition, you have the option of purchasing a power supply that allows for accelerated charging; however, this will cost you an additional $ plus.
- The activity of computer programmers Although it is not nearly as good as it could be, the camera's firmware is still in a state of back and forth. However, the external software is only the finishing touch. up until the point where it became completely unusable.
- A threaded tripod mount is not included in this package. However, there is an attachment to the shipping box that can be described as "very necessary" and "quite serious."
- Expensive for a set that already has jambs, and you will need to spend an additional fifty percent of the cost of this camera in order to be able to shoot normally and not just in the immediate vicinity of the outlet.