Graham Field 3085DZ: Efficient Clamp Compressor Tubing for Medical Use Review

What a piece of paper waste. I don't think there is a full thread on this. What's wrong with the manufacturer's engineers building such a piece of junk. For the first one, I used striped threads on me.

Good idea but the inner square piece that pushes in to clamp turns oddly, doesn't hold properly and the screws are a bit loose in the threads. They worked for what I wanted, just had to play around with them to get them to align very well.

Seems to be exactly what you need, but after a few pulls the threads tear and you don't press anything anymore. after just a few uses. Also, the tightening handle isn't very convenient. You need something to pinch it to really tighten it or you'll just scratch your finger.

This product is the reason you always, ALWAYS need to read reviews. Absolute lowest quality. I can't think of any use for him. On top of that I only got 8 clips instead of 12, but in the end it doesn't matter how many useless clips were in the bag. Non-refundable, beware!

The overall build quality of these clamps is pretty poor. The movable legs periodically tip and get stuck - usually multiple times as the clamp is tightened over light-weight surgical tubing. This makes them quite difficult to clamp completely. Worse, because the yoke is binding and not moving, it often looks like it's compressing the pipe completely to create a seal, but it's really just the yoke itself that's binding. This caused several leaks when I was using them. I won't buy them again.

It works but is not ergonomic and very awkward to adjust for two reasons. Small knurled screw. The part that compresses the tube is smooth and rounded, so the tube won't stay in place when the screw is compressed. I highly recommend the following clamp, just bought one to try - expensive but fantastic and very easy to control flow up to dripping at the rate of one drop every few seconds etc! Grafco Hoffman Flex Tubing Screw Compressor Clamp, Open Style, 1 x 7/8", 3083DZ (pack of 12) I've tried…

At first I wasn't very happy with the product because it didn't do its job very well . / made cheap. It doesn't quite work for me because it's too cheaply made and the part that pushes down tends to move when the screw is tightened, making it difficult for me to adjust the flow when it's not up positioned a certain way. As a result, I believe I have given a 2 star rating based on my own experience/unsatisfactory performance of the product. However, this is now a 1 star rating based on my…