Header banner
Revain logoHome Page
h5608 8-inch v-block clamps by grizzly logo

H5608 8-Inch V-Block Clamps by Grizzly Review




Revainrating 3 out of 5  
📏 Calibration, 🔍 Test, Measure & Inspect

View on AmazonView on ЯM


img 1 attached to H5608 8-Inch V-Block Clamps by Grizzly

Description of H5608 8-Inch V-Block Clamps by Grizzly

1 5/8" X 1 1/4" X 1 1/4". 1" capacity. Numbered and matched pairs are precision ground for accuracy.


Global ratings 3
  • 5
  • 4
  • 3
  • 2
  • 1

Type of review

Revainrating 4 out of 5

Good value for money.

I like these blocks because they are cheap and do the job. I usually work with them with trunks. I had to make some brass clamps to fit the screws so they wouldn't ruin the gun's finish. They are by no means professional, but I would recommend them if you don't have the money to buy more expensive blocks. Good value for money.

  • Calibration
  • Very Expensive

Revainrating 1 out of 5

Not as advertised

I didn't realize I was buying an open box. There is no mention of this in the description. i will send it back One of the clamps and one of the pulleys has been unwound and there is no shipping oil or grease on the parts. There is rust on the block and no paint on the yoke. I didn't open the rest of the parts. The styrofoam that came in the box is awful, it's crumbling and scattering little balls all over my office.

  • Check Measure & Inspect
  • Disappear

Revainrating 4 out of 5

Good tool at a reasonable price

This is a good set at a good price, at least for my level of work. I mainly used them for drilling round parts on a drill press. The clamps are secure and all finishes are as accurate as I could measure as an amateur mechanic. A nice feature is that the V is larger on one side than the other, allowing you to work with a wider range of sizes. I have also used them in clamp builds as spacers along with 1-2-3 blocks. The blocks are small and the clamping screws are long, sometimes getting in the…

  • Blocks V
  • Unbelievable price