🚙 Steel Front Grab Handles for 2007-2018 Jeep Wrangler JK JKU Sports Sahara Freedom Rubicon X & Unlimited - 7/8" Steel Rubber Grips (Black) Review

Love em. Very durable. I'm not sure why they didn't at least tell you which side is which. Look at the top hole - the top handrail hole on the right is sloped towards the right post. The same goes for the left. Small spacers go into the roof next to the sun visor. Long spacers go to the side.

This product looks cool, feels strong and is a nice weight. But their installation? drop it These bolts (see picture) are not tapered. Therefore, it is impossible to put them in place, they just tear and tear off, damaging both the bolt and the internal thread. Seriously, I want to return this junk. Or I wish the company wouldn't take shortcuts and provide the right tools for the job without wrecking my Jeep.

They are made of durable steel with high quality plastic handles. The bolts are very cheap and the handles are imprinted with "Wild Hog". A few tips: I would buy better Fastenal screws to install them. Find the top hole and run it. Before assembly, avoid the angle of the tapped holes to avoid confusing them during assembly. t Lower the bolt onto the windscreen support. It will drive you crazy with a rumble.

Robust design. Installation isn't difficult, but is a bit of a hassle once everything is lined up and the screws are tightened. I suggest threading the bolts into the body nuts a few turns and removing them to remove the paint from the threads so they can be finger tight to avoid cross threading. You also need to be careful when removing the factory screws from the rack. The pillar is sacred and the bolts can fall into the pillar. I rolled the business card into a tube and stuck it in the hole…

The handles themselves are good but a bit rustic. Terrible build quality. Installation is simple and straightforward, tighten the top screw a few turns and then start tightening the side screws. Alternate the top and bottom bolts when tightening. Very easy. The problem lies in the hardware. The screws used are the worst zero grade Chinese crap I've ever encountered. All 4 bolts are rounded. My grips are on and tightened but prevented me from ever pulling gear up or off. If I didn't have to cut…

It's always nice to know that you occasionally pick up the perfect fake. We all know why you're here. You wanted a GraBar set until you saw the price. $175 for signature metal pins is ridiculous. The markup is all stamped "American made". I mounted the handles in 15 minutes, tightening them on one side almost ripped off the screw head. Test him by putting all your weight on him, about 225 pounds, and he never complained. I'm sure I could break the bolts if I tried hard enough, but that's true…

I don't usually write reviews unless they impress me or make my lifestyle easier. They made both for only $20. My handrails (for the 18" JK 2 door) were packaged well and no instructions were required. Pretty easy to install. Pay particular attention to the end of the ratchet or the drop of one of the included spacers onto the dash. When you install them, you are very close to the windshield. I would suggest replacing the hardware and/or adding some Loctite to the screws. The included bolts are

I cannot express how disappointed I am with this purchase! I bought it for my dad to use in his jeep. Garbage! I installed the first strip on the driver's side. It was awkward to attach. Be very careful which screw you install first and TIGHTEN FIRST until both are in place. The bolt that went in the top hole (short bolt) did NOT go in until we had been working on it for almost an hour. Once in, it wouldn't pull out properly. I ended up having to use a rubber washer to fill in the gap. So I'm…