SEALIGHT 9005 LED Bulbs 14000 Lumens, HB3 LED Light with 400% 🔆 Brightness, Enhanced Field of View, Non-polarity and 6000K Xenon White, Pack of 2 Review

Acura TL 2012 This matched my high beam DRLs well. No flicker. Bright high beam and good daytime running lights. Pure white light with no engine DRL codes. Direct plug and play. Bought a second pair for my 07 chord.

I bought the whole set for my truck and they look a lot better than stock. The pictures don't do it justice. If you have a Nissan Titan ID we recommend that you partially remove and glue the tires in place rather than removing the entire front grille.

This is a really good product that really shines when compared to standard bulbs. These were for my high beam. They work well in this application. Only thing I wish they had a built in voltage regulator. On the Camry 2012, the high beam is also the daytime running light. In DRL low voltage mode, they have very little flicker. At full power they are great. Let's see if the flickering reduces durability.

I got them and installed them but they didn't work. This isn't my first install so I've started troubleshooting. Proved I had the power, but it still didn't work. I connected several jumpers to the battery and they caught fire. So I finally found out that the polarity was wrong. The connectors have a notch for snapping, but this is on the back. I hooked it up the other way around and they lit up right away. Not sure if I just have an odd batch or something, but they work. I fixed the plugs so…

BEWARE OF NEGATIVE FEEDBACKS! They will NOT fit the 2018 F150 fog lamp housing. The standard high beam bulb (9005) has fitted perfectly since the conversion. The diameter of the base of the bulb that the o-ring sits on is TOO BIG to fit in the housing. I've compared them and the Sealight is too big to fit in the case as they can't be inserted far enough for the mounting tabs to fit in the slots! I discovered this the hard way after breaking two of the three tabs after spending a lot of time and

After some research. I'm currently using the latest GE Nightbreaker bulbs, but that didn't really matter. I found these X1 versions. Which I liked because it's not ridiculously bright, but it matches my bright white LED strip. Overall, the light output is 100 times better than expensive high-end lamps from GE and Philips. My headlights didn't need to be dimmed. It was a direct direct landing. It comes with resistors and they fit perfectly in my case to hold the dust caps. I installed them on my

I installed them in my 2018 Mazda3 Touring and installed high and low beam bulbs. Installation is easy, just remove and insert the factory bulbs. Zipper closure to keep it from dangling. After doing all that, I reached out and turned on the light. Viola! bright lights! I cleaned my flashlight and zipped it up, closed the hood and backed out of the driveway and that's when the problems started. The My Check engine light came on immediately and the Service Your Car NOW lights in the infotainment…

Pros: + Instant on + Easy installation (unplug old bulb, plug in new) + Pure white light (no blue cast) matches my OEM DRL LED strip + Unexpectedly good packaging quality with molded closed cell Foam (more on that below) Cons: Claimed 6000 lumens but brightness is about the same as the standard 9005 hb3 bulbs my car came with (4000 lumens). It's a whiter color but not noticeably brighter - While the instructions aren't really necessary if you've ever replaced a car lightbulb, there were MANY…