🔦 7-Inch Round LED Headlight with Amber White Angel Eyes, DOT E-MARK Approved, Hi/Lo Beam, 6000K/3500K DRL Lamp Halo - UNISHINE J003T (1pc) Review

Excellent headlight, easy to install. Conveniently plug and play. We need to find a second hot wire for the angel eyes. Pretty easy on my Harley Davidson Street Glide. My only fault is that the tabs don't line up with the notches in my headlight so the light is a bit distorted. Still works great, just looks a little crooked when I drive to the garage door.

I bought this flashlight for my 2014 Street Glide Special. It fit perfectly and I didn't need another bracket to install it. The wiring harness that came with the light doesn't fit the bike, but I just ordered the correct wiring harness and it took about 10 minutes to install. The halo light can be white or amber according to your preference, you just need to connect the appropriate halo cable. Basically, I'm happy with the light. It hits hundreds of dollars.

Had to cut off a few grommets on outer ring to fit Dremel's stock body, no big deal. The headlights and light ring look great and outperform the old halogen streetlights. The problems are that the plastic on the lens is very soft and scratches weirdly when you look at it. Also, the body of the flashlight is a little thinner than the original, so the flashlight will rotate while driving unless you find a way to attach it to the body with glue or a screw. Overall happy with the purchase for the…

I wasn't expecting high quality for this price and found a few flaws but overall I'm satisfied. A few tips to make the installation easier. First of all, don't expect this to fit without modification. If you don't like that, I recommend spending more. Second, leave the protective film on the lens for as long as possible. This will avoid scratches during operation. Third, know that you will bind the ring. It's easy, but you need to find a wire for the running lights. And finally, pay attention…

Installed in RE Himalayan. Drops right into the Original Equipment headlight ring after bending the tab holding the stock headlight out of the way. The radiation behavior is "good". Not good. The low has a nice wide spread and a fairly sharp cutoff, but the pattern is a bit mottled, not very smooth. The big throws well down the street but is very centered, doesn't throw much to the sides. He also throws up. I had to tilt the headlight as low as possible so the low beam cuts off at a reasonable…