🪑 Quality Heavy Duty Drafting Stool Gas Lift Cylinder Pneumatic Shock - Full Stool Height Replacement - S6120-HD: Find Durable Upgrade for Drafting Stools Review

Works very well to turn my standard chair into a desk stand chair. I also really appreciate that as a taller guy, he doesn't sag very much under my weight.

I bought this HD gas cylinder because I'm a big guy and it works great. My only regret is that I didn't get it sooner. I'm glad I didn't. Now I have to kick out my chair! Thanks to the people who make gas cylinders!

A bit long. But it's not her fault. At the lowest level, it's 2 cm more for me - my feet can't stand firmly on the ground. By the way, I'm six five (195 cm). At maximum setting - just look at the picture. It also depends on the chair, of course, so make your own decisions.

We have several HON high stools that are used by heavier people so the lift cylinders fail prematurely. Instead of buying new chairs, the new HD lift cylinders bring those chairs to better days. Pretty easy to change, just follow the instructions and you'll cut the process down to 10 minutes after you've done it a few times.

works well im a big guy around 300lbs. and autumn. But I wanted a full-length chair that would match my desk at work when standing. It arrived on time and was easy to install. Dismantling the old cylinder was not so easy. I used deck rails and a hammer. Although I'm sure there's a much trickier way to get the job done.

It was easy once I realized the rubber mallet method of prying an old cylinder out of a chair was utter rubbish. You could bang on this thing all day and do nothing but break your base. Instead: I poured WD40 in and then loosened at the base with a large crescent wrench - it came out right after. If I did it first? Save fifteen minutes.

I just spent hours (literally hours) trying to get the cylinder out of my old chair. If yours isn't easy to figure out, just turn it in now while you can and buy a new chair. I hit this thing from all angles and used a piece of steel as a wedge to get the best angle. I used a hair dryer to heat the base plastic around the cylinder when it finally gave up. The upper part was much more difficult to separate. 5/5 for the actual product but I wish I was smart enough to try removing the cylinder…

Standard drafting chairs are not tall enough to stand upright at the desk. Replace the cylinder that came with your chair with this extended cylinder and you can turn any standard drafting chair into a work desk. My desktop is 42 inches tall. I weigh 240 pounds. When I have this cylinder installed, the armrest height is exactly 42 inches when the cylinder is fully extended. The height of the chair has gone from 31 inches (without me in the chair) on the original cylinder to 36 inches (without…