💡 Efficient 8-Way Axial Single Fuse Box: HELLA H84960101 Review

Don't listen to others about protruding wires. It's a bulkhead connector with opposite fuse access, that's how it should be. You can see in my picture the panel mount and how the connector should be installed. Fuses on one side, sockets on the other. It matches my other Hella connectors on this machine so it's original. The item came faster than the promised delivery.

This little fuse box is well designed and allows each fuse to be powered independently, allowing each to be powered from a different power source (switched or unswitched). Using it in my race truck is much more convenient and cost effective than separately built fuse holders. I cut a rectangular hole in my 0.25" thick aluminum panel and mounted it with the fuses and cover facing out for easier access to the fuses should I blow one. Two 5mm are included for mounting -Machine screws required…

Very practical. Supplied with transparent plastic cover and fuse clips mounted in the fuse box. You must use spade terminals to attach the wiring to the fuse box. I bought it specifically so I could mount it flush to the panel. I would make two changes, but both are quite small: - The terminals on the back of the connector are recessed deep enough into the housing that it will be very difficult to solder them - Neither side of the fuse box is connected to the bus. That would save me a massive…