💡 Enhanced Control with the HFT 96619 Momentary Power Switch Review

This switch could not withstand loads up to 10 amps. Stops working after 6 months of use. I opened it up, reassembled the internals and revised the simple hinge configuration. Now, after 4 more months of trying, I'm just throwing it away. The switch can work when the maximum load is less than 8 amps.

I have an old 10 inch Grizzly table saw and found it very dangerous to reach down to turn it off after cutting so I wanted to try this foot switch to secure mine to keep hands in place until the saw blade stops. I was concerned that the amp load would be an issue for the switch since the saw's initial amp load is about 18 amps, but it works great. I can now work safely and with full control on the table saw Thank you for a great product.

#1.it is very light and the curved plastic cable prevents it from lying on the floor. I took it apart and screwed it onto a small steel plate. The problem is solved. #2. I found that a pair of my (large) three-pronged plugs, when plugged into the device, prevented the pedal from fully rotating (and functioning) in the closed position. So I took it apart again and grounded it. a small radius in the plastic where the lid made contact with the enlarged plug. Problem solved again. It only took me a