🚗 Honda 44710-VG3-010 Front Wheels, 2-Pack Review

This is a direct replacement for 42710-VL0-L00ZB and is a perfect match for HRR2169VKA. Order 47710-VE2-M00ZE for rear wheels for this model.

It will take 5 minutes to install. Like the original front tyres, they do not have bearings like the rear tyres. The material seems to be the same, we'll have to see how they hold up in use.

OEM! Perfect fit, very easy to assemble. The self-propelled function of the lawn mower works again. The old wheels were worn out but the mower still worked great and I'm glad I replaced the wheel and not the whole mower.

I ordered the wheels from a BIG store who said they fit 'universally'. They were sold out and I sent them back and ordered the correct ones from AMAZON! My wife installed it in less than 5 minutes and the mower works great. She says!

I bought them to be able to transform into a transformer. I put two on my arms and two on my legs. I actually got a ticket and when they tried to pick me up I jumped up and ran away laughing. They were in shock😲😲😲 The only bad thing is that they have to be removed before going to the toilet.

IS NOT AN EXACT REPLACEMENT FOR THE ORIGINAL HRB MODEL WHEELS. A 3/8" wide gap between the wheel and the bolt causes the axle to move from side to side when bolted on. You will need 6 to 8 washers with a 1" OD and a 1" ID washer for a proper fit half inch and 3/8" thick. DO NOT RECOMMEND! DO NOT BUY!

It's very rare that the front wheels need to be changed. I don't recommend them and I'm not sure where to get the exact ones. I turned the centers to fit the bearings and took weights off the old ones. I still had the problem of them dragging when fully tightened. The only way to roll them reasonably smoothly was to loosen the bolts, but then the wheels came loose on their own.

I ordered these wheels and expected them to fit my Honda mower. The seller stated this is a direct replacement that fits my mower; However, this is not the real wheel. They look identical to the original wheels but do not have internal weights like the original wheels and they do not have metal bearings like the original wheels. The plastic axle hole doesn't even fit the axle after the original wheel is removed, it's too tight and won't rotate even when hammered into the axle.