🚰 Seamless Leak-Proof Bulkhead Fitting for Effortless Homebrewing Review

It's leaking. You can't seal safely. I read the reviews and thought I could fix this issue. It's not just threaded parts like the valve that go up to the nipple, the "bulkhead" part is just a nipple with a washer and then a nut at the back with some rubber washers. It will seep through the threads if you don't use the entire roll of teflon tape, and this may or may not work. I had to solder a washer to the nipple to make it work. Now about how the valve threads reach the nipple. They provide a…

Edit: Read the original review below, but the seller was quick to send a replacement unit (straight from China) with silicone O-rings, a free nozzle (nice touch) and a handwritten note. I had a replacement within a week of submitting my original review. Excellent customer service. Thanks very much! Good price for this part BUT on arrival the male threads on the bulkhead and barbed nipple were cut very deep (I'm a plumber/pipe welder by trade and know a lot about threaded pipe and fittings)…

Read many reviews about these valves. I chose this model because of the price, it was a complete build and it seemed to work well for those who bought it. Hole drilled and valve installed. In the "kit" there were a lot of washers and teflon tape, which surprised me. So that's the complete setup. There are no leaks and the valve is neither too tight nor too loose, just right. Now that I've brewed in a bag, I use the same pot for the brew and the brew. This valve allows easy transfer of the…