🔶 Enhance Your Ford F250 F350 F450 Super Duty with iJDMTOY's Amber Yellow LED Background Illumination Kit Review

Love these lights! 5 Stars!. worked long enough until the 90 day warranty expired, then the light stopped working as shown in the picture. I have contacted the seller about this but my headlights have just ended their 90 year warranty despite waiting around 30 days from ordering to fitting! I would steer clear of them, as much as I like them from the original install, they are rubbish.

Backlight looks good and works well! The only problem was the lack of installation instructions, so here's what I did: 1. Remove the emblem and thread the wire through the top slot.2. Drill a small hole in the recess behind the "F".3. Connect the ^UP^ cable. There is a small duct under the hood. I used a wire hanger.4. I have upfitter switches so I grounded one wire and connected the other wire to the switch wire.

Spent an hour and a half installing only to find they would not turn on. Read here that the wires are swapped (silver should be grounded but isn't) so I swapped them and they still didn't work. Finally said what the heck so I tried them right on my battery and none of them turned on. Garbage. Spent 2.5 hours putting everything back together and troubleshooting. lost Saturday. DO NOT BUY!

Don't buy this if you're going to spend your money and time installing it, half the lights didn't work. And Revain will tell you it's a third party, but they have nothing to do with it. So you have to pay your installer to install it and then find out it's broken and then send it back and pay again to put it back in your truck. See your Revain has a lot of stuff they say is a third party and your loss is lost

I love this mod. I chose yellow to match the side view of the F250. I tested them with a 9V battery before installing them. During installation I worked my way over the corners of the front fender. I ran a bundle of wires over the bare wires and tied them to switch #3. Tip: After removing the side markers, consider using this method. Make sure you have a crop tool and tighten. Pry in places as shown in the installation video.

Headlight checked before installation. Everything worked fine until I glued it to the car and untangled the wires. Checked, everything worked after posting. I connected them to the upfitter switch for now. The wiring isn't long enough to reach the truck so I'm wondering why they even make it as long as they have. This happens about 2 feet from the truck crossing. After I installed all that I closed the hood and now the 3 headlights on each side don't work anymore. Complete garbage. Basically I…