🌡️ Inkbird 12" NTC Stainless Probe Sensor Thermocouple Adapter for ITC-306T, ITC-308, IPB-16S Thermostats Review

Worked well until this happened - failure mode showed the unit was working well but the two dollar thermometer showed the reading of 35 degrees was actually 48 degrees. Not even close. Reset it a few times and I managed to get it to lag until I could find a replacement for Revain: Johnson Controls A421ABG-02C A421 Series Electronic Temperature Controller with pre-wired power cord.

Purchased for use with ITC-1000 during beer fermentation. On my model you don't need to solder the wires. However, I really expected better. The 2 problems I have is that the adapter cables are so short. The image shows the wires moving away from the edge of the image. nope they are so short Maybe 2 inches. So short that it doesn't reach my controller in the small project box. The second problem is that the probe itself is a non-standard size. I want to thread it through the rubber grommet in…

Works with ITC-310T if you are good at soldering. The original ITC-310T sensor is hardwired to the device. There is no place to connect this probe to the device. The probe should come with an adapter as shown in the pictures (they call it a DC cable). I didn't receive it, but I contacted Inkbird and they sent me one (actually two). This adapter needs to be soldered into the board in place of the original sensor connector. The circuit board of my ITC-310T had hot melt glue or similar applied to…