🐠 Acrylic Fish Breeding Isolation Box - Ideal Aquarium Incubator for Baby Fish, Shrimp, Clownfish Review

Pretty decent, had to use superglue to keep it in place. My package was also missing the most important parts. Screws and suction cups 😒

It's okay to glue everything together. It will definitely be a great box for mushrooms. There aren't any instructions, but if you have common sense, they're honestly not needed.

It arrives without instruction. It seems easy to assemble, but it's not. Won't stick together unless you use something like glue or tape, neither of which can be placed inside the tank.

Supplied in self-assembly packaging. I thought it was matte but it was just a protective layer. No directions. You can decide whether you want 1, 2 or 3 divisions. Fine and strong when ready - in about an hour. .:.

The item itself is very fragile and most likely will not assemble without a waterproof/aquarium safe glue. I used super glue and 100% silicone aquarium sealer to hold everything together. I used it for my aquarium bamboo.

I had to use glue to keep the bottom from falling off. It worked and I'm happy. I just wanted it to stay together after assembly. Either way, I hope the glue inside the tank doesn't come loose. I bought this insulation box for the hanging mount because the suction cups are terrible. With a hanging hook, it stays where you put it and won't fall off.

I didn't quite understand how to put this together at first. There are no instructions. Remove the plastic covering from both sides of the parts. Set the cover and center bulkhead aside when reassembling. There are screws and brackets that go through the side holes, first see where they go by looking closely at the photos in the listing. Use short screws. Once everything is in place, glue it together. It wobbles a bit, but much better than clean ones.

This is a set of CNC cut clear acrylic parts. Everything fits snugly and is secured with the included acrylic tabs and screws. The only tool required is a Phillips screwdriver. The first step is to remove the protective film from all parts. Then lay them all out to define the bottom, sides and top. Place the end tabs in the slots to make the main box. If you add screws you can use a rubber band to hold it together. No glue needed if everything is tight. It's worth paying attention to how the…