ISPINNER 100Pcs 1/2 Inch PEX Cinch Clamps, 304 Stainless Steel Cinch Crimp Rings Pinch Clamps For PEX Tubing Pipe Fitting Connections (1/2 Inch) Review

I've installed a lot of these already since my purchase, great quality. I would definitely purchase again will buy again.

Clamps fit too loose when placed onto 1/2 inch PEX. If working in a tight area the crimp head swings to a downward position. it is then difficult to clamp if you don't have a third hand. There are available clamps that fit snugly onto PEX and that is my preference.

Used to secure home run lines from manifold to end devices. Used roughly 30 of the 100 and none failed nor came faulty; I inspected each one upon arrival.

The fact they they aren't a tighter fit on the pex tubing make them a bit hard to keep steady and crimp with one and, but other than that they work as they should, I do two cycles of my tool on each clap just to be safe.

A little lighter and have to crimp them slightly before you place them so they dont slide all over the place. But they work just fine. If your not a professional you may have issues. I call inexperience on that. But work fine no problems. No leaks.

I have no complaints about this product. I am a home improvement contractor and I have installed these in 3 different houses so far. I approve this purchase.

Purchased for a bathroom remodel, always good to have extra of these around. I became over zealous at times and had to cut a few off. Stubborn clamps to remove once crimped. Therefore I have the utmost confidence in the properly positioned clamps and eager to get water back on soon.

I am almost done converting to PEX from old grey pipe in my trailer. I needed extra clips and picked these up for a good price. They look identical to the ICrimp clips that came with the tool and have worked flawless. The little plastic case is super nice so you do not have clips tolling everywhere when you are working. Sometimes it is the simple things. I do recommend this item and would gladly buy it again.