🔧 Enhance Your Tesla Model 3's Safety with ITM Set of 4 TPMS 433mhz Tire Pressure Sensors - 2017-2018 Model Compatible Review

I used these on my second set of winter wheels. They were installed by Discount Tires so I cannot vouch for the installation process. But they work fine.

I bought these for two different wheel sets that I use on my Model 3. They all worked great. I got a TPMS error code but ignored it and drove it for a day. The code disappeared and the print appeared. Works well.

Bought a set of these sensors for my Model 3 (snow tires). They were easily recognized by the car and were significantly cheaper than those available from my local tire dealer. The pressure is stable, at 2k there are no errors.

I bought these after reading reviews to use on my 19" T Sportline TSS wheels. Initially they didn't get in touch even after the old bikes were returned home and I rode 40 miles. I ended up getting a TPMS warning. When I got home I restarted the MCU (pressing both scroll wheels). On the next ride, TPMS checked in and a display appeared to select a new wheel configuration. I have asked the tire center to inflate to 44psi and all 4 tires are reading 42psi today. I'll check it with my meter.

After more than 6 weeks of use, I can say that I am satisfied with these sensors. They cost a lot less than the specialty store that sells TPMS sensors. My hoop jump was a little confused as they wanted to program them first but they don't really require any setup or programming. When fitted to my snow tires, within 2 miles of my first drive, they automatically synced to the Tesla Model 3 computer and resulted in an on-screen calibration question. Once you enter the new wheel size on the…

Installed with torque specifications of 2 Nm (18 in. lb) for the torx mounting screw (with blue anti-vibration sealant already applied) and 4 Nm (36 in. lb) for the torx mounting screw .lb.) pounds). ) for the main valve clamp. Upon entering the vehicle, select "Tools: Reset TPMS" and the console will restart. After about 10 miles of riding there was a warning that a new wheel configuration had been found which I discarded. Checking the pressure at this point showed that all the sensors are…

If you buy these odds it's because you didn't buy original wheels for the model 3. I bought them to use with Vossen VFS1 wheels 18x8.5 front and 18x10 rear. The sensors work fine on the Tesla, but the problem I have is that the rear valve stems are too long and hit the calipers every time the wheel spins while the valve stem cap is in place. When I remove the cap there is about a 1mm gap but with them it gets in. The front valve stems protrude about an inch past the calipers. I'm going to a…