Jtron 12 32V Holder Warning Automotive Review

This fuse box was the perfect solution for my custom motorcycle accessory installation. Hides easily in the motorcycle and allows you to place all accessories in the middle.

You get voltage even if the fuse is blown. In order to light up the LED, the voltage is fed through the fuse box. Can you pull the fuse and still have a voltage transfer to the other side? Another piece of cheap Chinese junk.

Works as advertised but would recommend covering the back with additional 3M tape if you plan to mount it to a metal surface. the positive bolt only has a small insulating pin, and as it wears out over time, it shortens.

I checked the large fuse box, this box works just as well, these are good boxes. I use these boxes in many off-grid renewable energy installations. Also my boat and pickup to which I added headlights.

I have bought several. There is simply no protective cover for the main link bolt. I usually do something with a shrink or rubber lid. I usually started one with "Accessories" and switched it to "ON/Run" with a relay between the battery and the fuse box. Plug the new device into the empty pin header and insert the fuse and the new installation gets power when I want it to.

I use these fuse blocks in my "GoKits" amateur radio. 6 cycles is more than enough. My only complaint is that the clear plastic cover is very difficult to remove to replace the fuse. I finally decided I needed to cut off the little plastic finger that is the latch and found that the lid was tight enough to stay in place even without the latch. (My application is not exposed to strong vibrations.)

They are better than built-in fuses to protect additional accessories. All fuses are supplied from a common terminal. Everything is covered except for the power connection, which should also be covered for safety reasons. The device can be bolted to simplify additional wiring. I use two of these fuse boxes, one from the battery and one from an auxiliary circuit.

It is always risky to connect to the wiring of old cars. Using a simple relay I ran a wire straight from the battery. The relay is controlled via an old radio line. When you turn the key, the radio wire switches the relay and connects power directly from the battery to the new fuse box. Do not stress old cables. I added some sensors to the car and a new, more powerful stereo. And what's nice, if a fuse has blown, there are indicator lights to let you know. And a hard plastic cover to protect…

Nice compact fuse box that fits under my F-150's dash to power the brake controls and reversing camera monitor, with extra connections if needed. The only reason to give this 4 stars is that I had to take it apart to adjust the two small retaining tabs that hold the lid in place. On the one hand, the retaining tab had to be bent slightly outwards in order to better grip the recess in the lid, on the other hand, the flexible retaining element had to be slightly scratched and bent so that its…