📲 Wahoo K-Edge Gravity Cap Computer Mount - Securely Attach Your Device in One Size Review

I took the head off my MTB and broke the old bracket while the handlebars were spinning. With this stem mount, my computer is centered right where I can see it. Also clean the grids for my light and bell.

It's awkward to align because you have to tighten it without seeing if it's straight. If it doesn't line up properly then you'll have to loosen two small screws to get the adjustment and try again. After doing this a couple of times, one of the small screws holding the blue plastic to the bracket broke and had to be replaced. Pooh.

Easy to install and very reliable but I don't like that it's directly above the headset as its position means you have to look down at a pretty acute angle to read it and it doesn't attach on the headset but protrudes slightly forward (over the stem) making it legible without looking down too hard, but still very reliable.

Easy installation on my Madone 9.2 Aero handlebars with integrated cables. Others noted that straightening was difficult. If you write down where you want and make sure the etched lettering is in the exact spot when you tighten the screw; You will have a perfect installation the first time, every time. I think this mount will be very strong and could be switched to a different bike in the future if needed.

Installation was easy. The calculator was a perfect fit. However, be aware with this particular mount when using it on an MTB, the underside of your computer will be subject to impact from your body, knee, etc. My impact was therefore caused by a knee impact. If I had gone with a mount that placed the computer in front of the rod bolt, it would have survived. So it's worth spending the extra $$ to get another offer from this company.