🍻 KegWorks Heavy-Duty Beer Faucet with Hex Nut Wrench - Enhanced for SEO Review

Well, there are a lot of bad reviews I've read. Some of them look like people haven't read the product description. The hex side is a 1" nut size. As far as beer dispensers go, I'm not exactly sure it's the best, but for Nitro fridges it works amazing. It's a faucet that looks like a beer faucet. If you 1- inch screws. It works.

The "wrench" part of the wrench couldn't loosen my faucet ring and just kept slipping and ripping out, scratching my faucet nut/ring terribly. Also, the side of the wrench didn't fit the inside nut of my Edgestar kegerator. If you contact Revain to return this item, this item will be listed as non-returnable. I do not recommend.

The pen was good but nothing more. The hook on the end that goes into the round part that holds the beer tap is too short and slips out too easily. I bought this for the most beautiful pen and what I thought was the best. But since the end was too short to securely lock onto the ring being released, it didn't work well unless the ring was very tight to begin with. I need a longer tip.

Waste of money. The hex side is too small, and the tooth that protrudes on the faucet side to hook into the faucet collar is too short, and when pressure is applied, it will immediately slip out. Not only could I not tighten the faucet enough, but when it slipped out it scratched my new $60 faucet. And I'm just lucky I didn't try to use it until about 40 years after I bought it, so it's bad now. To return. Complete and useless waste of money.