🏍️ KEMIMOTO Ninja 400 Fender Eliminator & License Plate Bracket for 2021 Z400 and Ninja 250 (2018-2021) - Compatible & Reliable! Review

If anyone is interested. also suitable for 2020 N400. I couldn't put the license plate light sockets in the holes where they were supposed to go, just used them as washers on the back of the screws under the metal screws. Went like clockwork. The grommet that sits in the center hole of the faceplate bracket is actually for the wiring that goes into the bottom of the end piece, I think that's why some people report the faceplate 'gap' when they put it there leave when installing the front panel.

The stock fender was difficult to disassemble. Reusing turn signals and license plate lights was also a challenge. I couldn't even mount the metal parts on the back of the turn signals. My kit didn't have rubber pads so the license plate light is dangling but I contacted the seller and he agreed to send them to me. Also, NO hardware other than four mounting bolts and nuts is included. The part itself is solid and easy to install if you have a built in taillight. He loses a few pounds and looks…

A very good kit to repair a disgusting original grand piano at a good price. Put it on my Z400 and it looks so much better. There were no instructions but as always there are YouTube videos to help if you are unsure. It's pretty simple; The hardest part was getting the turn signal bushings into the new bracket, but with a little patience and strong fingers you should be able to do it. I had to push it halfway through and then use a thin but blunt tool (an allen wrench in my case) to push the…

Installation is very simple. Disconnect all stock wires, take out the filter from the rear, remove the fender, remove the turn signal and signal light from the stock fender, reinstall the plate, turn signal light, turn signal, filter wires to the bike and pull the screws tight! for the gap for the tag display seems a bit weak. But it's wrapped tightly. It would lead nowhere, but Milady was skeptical. But otherwise it worked great. Bought it for her on a new 2019 400. She is very happy that this

Well it's an easy install if you don't use OEM parts but if you really want to get the most bang for your buck order this fender separator and use OEM parts, you really need them twist . there it is a really tight fit which i like no play, with this kit comes a tight rubber grommet that they put on wherever the light goes but you have to take it out to install the oem light you use this grommet to tighten the cables after you've got them all attached above, if you want a great video that looks…

It was pretty easy to install. There weren't any instructions, but let's face it, most people will still check out how to do it on YouTube. Be sure to keep the grommets and washers that came with the license plate light as you will need them when fitting the light to the rectifier. Do not break screws with a power tool unless you have an impact driver and an appropriately sized bit. Even then, be careful because they are easy to take off. Only really a problem if you want to leave the factory…