Header banner
Revain logoHome Page
key fob shell case fit for keyless entry remote car key housing replacement with free screwdriver (casing only without blade) (2pcs) logo

Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs) Review

5

·

Very good

Revainrating 4 out of 5  
Rating 
4.2
🔑 Car Key Shells, 🚗 Interior Car Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs)
img 2 attached to Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs)
img 3 attached to Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs)
img 4 attached to Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs)

Description of Key Fob Shell Case Fit For Keyless Entry Remote Car Key Housing Replacement With Free Screwdriver (Casing Only Without Blade) (2Pcs)

Easy to install key case,All you need to do is switch the internal components from your old remote key fob to our new key case and install your original key blade on this key case,No programming is required. This key fob cover is a replacement for the aftermarket segment, not the OEM.Note: no internal (remote/electronic/transponder chip) units. This is a good replacement case for car key remotes where the keys are damaged or the key case is broken or additional spare key.Can save you a lot of money. If your existing key remote shell looks the same as the picture shows,this keyless entry remote key fob shell will fit. Please notice that this replacement key shell doesn't have a chip holder. This replacement smart keyless remote control housing is made of high quality materials for durability. If you have any questions about this keyless remote control case, please feel free to contact us.

Reviews

Global ratings 5
  • 5
    4
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Poor Quality Control

Will not engage due to blade holder not seating properly in slot. Therefore, one side of the case does not close. This is for my 2010 pilot.

Pros
  • Best
Cons
  • Update available

Revainrating 5 out of 5

broke quickly: key inserts

ours broke after a month and a half despite glue and tape trying to reinforce it. Good thing they cost $10 versus $350 for 2 keys which we paid after trying this.

Pros
  • great option for me
Cons
  • useless features

Revainrating 1 out of 5

Doesn't go well with key inserts

I needed this because my old cap had a screw ripped off and cracked. I couldn't seal this properly so I had to use my only spare key and make this new mess a backup. It's not worth it.

Pros
  • Satisfied so far
Cons
  • There are new competitors

Revainrating 5 out of 5

bad landing; but then it was cheap

Didn't fit my 2009 pilot. The included screw goes in deep enough to hold it together (for now), but the "guts" of the electronics are too thick for the sides to fully engage, leaving a gap at the edges. This may take a while with tape along the edge of the crack so I think I can get it working for the money it's worth.

Pros
  • Lots of positive emotions
Cons
  • Secret

Revainrating 5 out of 5

Tight fit but that's what you need.

After reading some of the comments I was concerned that this fit would be so tight that it couldn't be done right but it was great. You can be sure that the original key fob assembly was also securely mounted. You'll have to take your time and be sure to get things in the same position and orientation as the original, but in the end everything will fit together cleanly and solidly. Perfect fit for my 2010 Honda Accord key. I don't see any reason to overpay for replacing the case of another key…

Pros
  • certified
Cons
  • crumpled