⛳ Kuang NEW Club Car 12V Gas Golf Cart Solenoid (1984+): DS & Precedent, Model #1013609 Review

Easy to install by paying attention to where the wires go when removing the old one. It fits perfectly and solved an issue I had with intermittent starting reliability on a 25 year old cart.

After hours of trying to change the solenoid valve on a 2001 Club Car I couldn't get it to work. I borrowed a used one from another car and it worked. I don't know if this new solenoid is bad or if there were any compatibility issues. Disappointing.

Bolt broken off with 1/4” ratchet and 10mm socket. I almost touched it and it burst. Low quality. Luckily I ordered 2 as I've had this problem in the past. LOW QUALITY CHINESE METAL. Sometimes you can buy cheaply made. Order 2 and you might get a quality part with a 50/50 chance.

Bullshit! Don't waste your money. I put this on and drove about 5 minutes and it started smoking and smelling like paint.! I did nothing but spent $20 on it. I should have known not to buy it. Apparently everyone has the same problem. This seller should remove this item from Revain!

I bought 2 new Club Car 12V Solenoids and both get hot after half an hour of operation and turn off both Club Cars to wait until they cool down and start them up and turn them off again after half an hour, running them several times with the same problem. It is not recommended for Subaru club car engines.

The 3rd one I bought for the same cart, the 1st took 1 hour, the 2nd 10 minutes, I checked the whole system for errors and no problems found, so I drilled out the rivets and looked in, GARBAGE! The contact plate is just a smooth plate of copper and there weren't any wires to solder to it. Cold soldering everywhere. Don't waste your time I'm sending this 1 back without even trying, spend more but hopefully last more than 60 minutes.