Enhance Performance with labwork Beige 8 PCS 1200° Spark Plug Wire Boots Heat Shield Protector Sleeve for SBC BBC Review

I'm a bit disappointed with the color. . It's actually a salmon color, not the one in the photo. I'd rather throw it away than install it.

The sewn end is fine but the metal ring on the other end is too small. Only works if you have a plug wire harness that is not already crimped on one end.

Very good protectors. good color Can't beat the price. I have them for 73 Dodge D100 with 360 and headings. Fits perfectly over my MSD superconducting spark plug boots.

Thick enough to be used for glass blowing (holds a hot hollow sphere). I like that it looks like a sleeve because it fits over the grill tongs and allows me to get closer to the glass. Excellent price.

I bought these boots for my Chevrolet Tahoe 00 5.3 liter engine. The idea is solid, but these booties will never fit spark plug wires designed for any car unless the wires are very thin and much smaller in diameter than these booties. The boots have a metal O-ring on one end that affects their fit. So they don't really fit.

Cool product, looks good, does the job and for the money it's worth investing some time adjusting for a fit. 2008 C6 LS3 connector and cable. One end of the sock is sewn, the other end is bent onto a metal gasket and tucked into the sock. The metal O-ring itself is slightly smaller than the rubber boot that goes to the coil pack. To make this work I had to open the sock at the end of the o-ring and ignore the metal o-ring, then thread the heat shielded spark plug wire through the sock, and then