lenboes Original Micro TF SD Card Slot: Replacement Repair Part for Nintendo Switch NS NX Console 2017 - High-Quality Solution Review

I was getting SD card errors on my switch and then it finally stopped recognizing it completely so I ordered this replacement. Once installed it worked as intended (make sure you ordered the Y00 screwdriver!) but I also found that the original screwdriver worked fine even after reinstalling. So the small connector must have come loose at first, which could have been repaired without this part.

There is not much to say about the spare part. As long as it works like stick, all is good. It works - at least as long as it works for me the same way it does in stock. However, it should be noted that they did not include a piece of adhesive foam. If you lost your original part, you will need to build something else. If it's no longer sticky, you can probably use double-sided tape to hold it in place.

I ordered 2 micro TF SD card slots for Nintendo Switch. The first card reader was DOA - I was able to verify this because the stock OEM card reader worked. The second card has arrived shortly, and while it works, the screw hole and alignment hole are disabled. Once the screw is in place to hold the reader in place, the connector must come loose due to the extra force applied to the ribbon and connector. The second one works at least, but I can't build the switch. Find an original spare part…