🔧 Enhance Performance and Style with Tundra Leveling Lift Kits: 2007-2021 2WD 4WD 3 Review

Works great on the 2020 Toyota Tundra SR5 TRD Offroad package Raised the front end exactly 2 inches. I would buy this alignment kit again.

Took this kit to my local mechanic for installation. Lined up the front of my 2004 Tundra well. Very happy with this purchase. A resemblance collapse is recommended after that to perform.

No real instructions included but found on YouTube. Spent a few hours and some fat on a day off and was very pleased. All in all, it's pretty easy once you understand the mechanics. After installation, alignment is MANDATORY.

They fit perfectly, but you may have to be prepared to remove your vehicle's anti-roll bar link or upper ball joint to get the clearance required. I didn't have the right tool for it when I tried to put it on and had to back off and wait to put them on. You don't want to damage the ball joints with the wrong tool.

Would have liked to see extensions to the original strut bolts rather than rotating the strut 45 degrees and threading the bolts into spacers which made it difficult to align the bolts and gasket threads tightly in place. Otherwise this gasket set appears to be of good quality and the truck has risen 2 inches as the description states.

Installed on the 2018 Tundra 4x4. For under $50, it was 100% worth it!Photos in the garage before installation.Installation is drab, but the spacer has nothing to do with it. My mileage stayed the same. There were no problems with the adjustment of the front axle. After a week it has settled down and seems perfectly aligned with its back.

There were no instructions for the box but I watched a YouTube video of a similar product being installed. Additionally, there are no marks on the leveling pads to mark the inside and outside, making it easier to place them correctly during installation. Luckily I'm a badass and I KO'd him in about 6 hours with some elbow grease with noodles and some sweat. My Tundra 2017 looks great now.

Installed on my 2001 Toyota Sequoia with no problems. Raised about 2-1/8 inches. I don't know why the seller only lists the Tundra since they have the same type of suspension as the Sequoia. Same bolt pattern etc and remember you will need to rotate the post 180 degrees to match the hole pattern. It's easy to install and mounts in one direction only, so you can't mess it up. Not recommended if you are going off-road! These spacers increase the dropout distance and stress the upper ball joint…

I bought 4 tires Yokohama Geolander A/T G015 275/70/17. They were too big for the front of the car. So I bought this item last week and now the body is cleaning the tires. The tires still hit the inside of the frame a bit when turning full right or left, but that's not the product's fault. I installed them and just picked up the car from the shop. It seems like a good product. It wasn't a real wheel alignment kit for my car. I measured on level ground and the rear measures 35 7/8 inches from…