💧 High-Performance Lifegard Aquatics 1-Inch Bulkhead Fitting Kit: Ideal for Efficient and Leak-Free Water Flow Review

Not mentioned anywhere but listed on the box this kit requires 1.75" holes. So if you're like me and your tank is pre-drilled with 1" holes they won't fit. fit.

I received the item on time and everything worked great. I can say that the quality of the material is high, the parts are perfectly matched, so the installation was easy.

Installed on my Fluval FX6. I like the flat air intake. The "small" exit is a game changer! Much more flow. Excites the surface of my 75 gallon full or you can run it deeper and create a current.

Good quality plastic used, included everything expected but measurements are inaccurate. The fitting is 1 3/8 ID and 1 5/8 OD, so a 1 3/4 hole is required. at its widest point it is 2 1/2 inches. Get ready to cut a bigger hole like I should have.

Something is wrong with the rubber in the seals. I bought at least 10, EACH LICKED. Before I left a bad review (I hate it) I called them, the guy isn't there, the girl I spoke to will leave a message. he will call me right away. Never heard of BAD customer service, price was great but you get what you pay for.

I just installed two of these on a seawater tank. I used caulk sealer with the rubber washer provided so not sure if it will hold water without liquid sealant, haven't tried it. But for a few bucks, I'd rather play it safe. Very satisfied so far, especially since it comes with a screen for the internal tank and a barb connector on the back.