🚗 AIR LIFT 80537 1000 Front Air Springs Kit Review

If you shovel snow - buy these - they take the slack out of your front truck - pump up 40-45psi and your gold - Also use morning soap straight out of the bottle when installing and lubricate the whole pillow - if the bag starts to dry out when attaching it, just splash some water on it - this will help the pillow slide better through the spiral spring - smile and let's plow - :+)

Well they certainly work, bought these to make sure my front didn't fall through when plowing. The pockets are strong and I trust they will hold up well. I'll update if they don't. Now for the bad. The instructions are terrible. You're better off on YouTube. They give you exactly what you need to properly center the bags. The tee and clamps suck as hell, they don't even sell them in the aftermarket in their own store. There are a few vendors here that sell fitting and hose covers, get these…

Yes Sir! Old Thunder sits like a show horse! In fact, I bought them to smooth out bumps on my 1-ton twosome when lugging my fifth bike with a bed full of firewood. I load hard because when I get to camp I'm on my ass. They're pretty easy to install if you've got a mechanical flair. And they cover failures. I also have a four position manual control installed on my truck so I can level my truck in almost any situation I might find myself in.

Oh my god these things are always "BOMB"! I really needed this for my F-250 to prevent my truck from going down with a plow attached. They work great and were so easy to install. Besides the preparation, the installation took about 30 minutes. Check out the video on my UTube channel "The Plow Guys", I know a bit of shameless plugging. Excuse me. Click Yes if you found it helpful. Update 05/03/2017: Still works great. They never lost air and worked all winter without any problems. I will keep…

Fitting the airbags to the front of my F250 was fairly easy and straightforward. The hardest part was getting into the spring as I didn't drop the front end. But after that I was fine. I think figuring out if you're running the airlines too hard and placing the schrader valve was the next tricky part. But it's just hard to think and understand. To make the job easier, buy metal tees to connect the line, the lines just snap into place. You can see the t-shirts in the pictures. Then buy an…