LUXE Bidet Universal Toilet Adhesive Review

I bought these to support the toilet seat after installing the bidet. My husband and I rarely go to the bathroom and are both thin. One of the pads has already started to break in half! I have no doubt they won't last more than a month or so. Very disappointing and not worth the money!

The luxury bidet will not function properly without additional/higher toilet seat bumpers. One or the other is fine. I find that superglue works better than the glue that comes with it. Be sure to prepare the surface as directed and the included tape will last a while. After they fall off, use some super glue and a "C" clip or rod while the glue dries.

Works as it should, but (and I probably should have thought about that before ordering) The seat is so high that when the bidet is on, water flows out of the wide gap between the toilet and the toilet seat. In fact, I accidentally spattered my clothes a couple of times, which really upset me. As others have written in their reviews the lifters are very securely attached to the seat which for me is a bummer trying to take them off so my clothes don't get wet every time I use the bidet head…

High quality metal fitting and hose included. The Luxe even included duct tape and a plastic key. It was a pleasant surprise. The bidet itself is durable and of very good quality. You don't need to twist the thread very high at all for this to work. Raising the nozzle too high can remove rust from the sheet metal. :-) The only disappointment was the installation on my existing round plastic toilet seat. My old toilet seat didn't have a flat bottom. This discovery required a second trip to Home…

I recently purchased a Luxe bidet and installed it in my master bathroom. As I did so, I realized that by adding this device under the toilet seat hinge, I had raised the back end and tilted the seat a bit. My wife didn't notice but I found it at an odd angle. I bought these bumpers but I was worried they were too high. I've read some conflicting reviews about it and was concerned that I might attach them to the toilet seat, only to find that they worsen the angle of the toilet seat in the…

After reading some reviews I decided to buy these bumpers although many reviewers said they did not fit well on the underside of the seat. After installing the bidet myself, I saw that bumpers are really needed to align the seat. I note here that I have a wooden type toilet seat with a fully flat painted (glossy white) finish. Based on the reviews, I decided to gently wipe the attachment point surfaces with alcohol wipes to improve adhesion. After waiting a few minutes for the alcohol to…